Bryston 4B gets HOT. Should I leave it on?


My 4B is 25 years old and gets smoking hot. I sherk my hand when I touch it. Is this seem normal for an old amplifier? It's off the ground and I'm going to add a fan near it to help ventilate...

My entire room gets warm because of it! I would rather turn it off when not in use to 1) save power and 2) reduce the heat buidup. However, I've been told that leaving it on is both better SOUNDING and EASIER on the components (less wear and tear). What do you guys think? Can I turn this oven off?
128x128baltman
Turn it off now! Heat (read excessive heat, above normal operating tempatures) convert into an inverse quadratic equation. That is each time the temp goes up "x" degrees over its intended operating temp, the wear factor is something like four times the norm.
There is probably something about this none of us know, so just be quick about getting yourself and your gear out of possible danger.
Bryston has a stellar reputation for customer service. Call them asap.
Good luck,
Larry
Most Bryston amps I have ever owned even when on 24/7 never get any hotter than just warm to the touch. I wouldn't leave YOUR AMP on till you get it repaired/inspected by Bryston.
Interesting... Bryston USA told me that they don't recommend keeping it on all day. I guess I'll keep it off most of the time, and hopefully it won't break :)
A) Bryston's are not high bias amps and therefore will not benefit as much as other amps that experience wide temperature swings between normal operation or being turned off.

B) Your amp is defective if it is running as you described it. While i hope that it does not "terminate itself" on you ( it's already broken according to what you stated ), i'm sure that it could sound better and pull a LOT less power than what it currently is.

Good luck... Sean
>
I've owned 4B's over 23 years, they depend upon lots of unrestricted air movement for cooling, put one in a closed in area and it will get too hot to touch! they produce a lot of power, and summer, heavy use, restricted air all can and do add to the heat. However that said, if it is getting as hot as you describe, and its got lots off available air [I always put mine on at least 2 inch tall 2 inch wide 12 inch long blocks running front to back, always placed with nothing above or below] I have had this occure more than once, if its the same thing you have a slight service problem. the remedy is easily preformed by any qualified tech. it is a simple adjusment of bias, usually one side gets hotter than the other, bingo. However whatever the problem, do yourself a favor, take care of it asap, I have twice had post warranty repairs to 4B's the bills were in Can.$110.00 and $130.00 I have a Bryston preamp and 8 Bryston amps in my system, and I'm damn glad I do.
p.s. a favorite way to place a 4B is alone on top of a milk crate, the kind that used to make good record holders, that proclaim property of so-and-so dairy, non-dairy ones are available from wall-mart type retailers, painted black, and with lots of the sides cut out, the 4B fits like it was made to, and placed behind a speaker. after all the less speaker wire the better. [i use almost none even though crossed over 5 ways, using 8 amps] Lastly, this set up has actually cured me of a never ending desire to upgrade that had lasted over 25 years, since the first day of 2003 over 7½ months, and still absolutely satisfied.