2. analog
  3. 1325551242

Eminent Technology ET-2 Tonearm Owners


Where are you? What mods have you done ?

I have been using these ET2's for over 9 years now.
I am still figuring them out and learning from them. They can be modified in so many ways. Bruce Thigpen laid down the GENIUS behind this tonearm over 20 years ago. Some of you have owned them for over 20 years !

Tell us your secrets.

New owners – what questions do you have ?

We may even be able to coax Bruce to post here. :^)

There are so many modifications that can be done.

Dressing of the wire with this arm is critical to get optimum sonics along with proper counterweight setup.

Let me start it off.

Please tell us what you have found to be the best wire for the ET-2 tonearm ? One that is pliable/doesn’t crink or curl. Whats the best way of dressing it so it doesn’t impact the arm. Through the spindle - Over the manifold - Below manifold ? What have you come up with ?
128x128ct0517
ct0517's avatar
ct0517 OP
2,041 posts
 
I don't even see a shipping price as this appears to be a US sale only.
I know a couple people looking on this side of the 49 parallel but they cant buy it.
I don't blame the seller - he's probably dealth with irate Canucks as US/Cdn customs are a huge - PITA. sorry just venting a bit.

As a seller I would have at least made sure the presentation is good.
if this was a car ad two of the four tires are not even touching the road in the first ad.
That ET2 will never get past the first groove if left in that condition - for those considering one.
frogman
7,373 posts
 
You raise a good point, Chris. It's those little details amd oversights on the part of a seller that are deal breakers for me when considering a used item. IOW, if the seller was so careless as to not even make sure the points of the cones are in the cups, what other things was he careless about that might have even more important ramifications re the condition of a fairly delicate piece of equipment?
manitunc
795 posts
 
Do you think there is a markup for medical equipment?
http://www.ebay.com/itm/Hiblow-Air-Pump-SPP-6GA-for-Tosoh-AIA-600-Immunoassay-/170637232077#ht_3419wt_1161

I just purchased the same pump on ebay for less than $50. good thing Bruce didnt see this.
slaw's avatar
slaw
20,498 posts
 
Rugyboogie: If you set your mind to it, you can make a trough fairly easily. Get the appropriate diameter pipe. Cut it in half. Find an adhesive similar to the 3M and GO FOR IT! It's really not that hard.
slaw's avatar
slaw
20,498 posts
 
Rubyboogie: Sorry, I just assume others have access to the necessary equipment for these things. After cutting the pipe in half you could fashion an end piece. It can all be sealed by silicone.
More to discover