2. analog
  3. 1120380254

Why one side is very much louder than the other si

I have newly setup my VPI HW-19 MK III with SME V arm and Benz Micro cartridge using Musical Fidelity X-LPS as Phono stage. My other system is:

Power AMP: Pass Lab x-600
Pre AMP: Pass Lab X 0.2
Transport: SONY SCD-1
Speaker: Goldmund Apologue
Power Cable: NBS Professional
Interconnect: Transport to Pre-amp : AudioQuest Sky
Pre-Amp to Power Amp : Synergistic Research Designer Reference
Speakerr Cable: AudioQuest Dragon

As you aware, I have been switch from Vinyl to Digital for last 25 years. This is first time after all these years to try on vinyl again. Unfortunately, the first result is not successful. When play the vinyl record, one side of the speaker is sounding normal, while the other side of the speak is hardly able to hear. When I exchange the interconnect from Turntable to phono ie. swap left to right, the result is reversed. Can anyone able to help me how to solve this problem. Kind regards

LOU
clwong

Showing 1 response by dan_ed

dan_ed
2,451 posts
 
Lou,

swap the leads at the back of the cartridge. That will tell you if the problem is in the tonearm wiring. This will also indicate if you should suspect the cartridge. If the tonearm wires check out you'll just have to go over all of the settings. Recheck the alignment. For now just set the arm as level as you can with the platter surface so that VTA is reasonable and make sure your VTF is within range. Make sure your azimuth is not way off.
More to discover