2. amps-preamps
  3. 191434-23267

What Power Amplifier Should I Buy?

I am looking to increase my system power. I currently am using a Bryston 2.5B cubed, which is specified at 135 Watts/CH. I am using Revel f208 speakers crossed over at 120 Hz to a 15" HSU sub. The f208 speakers have 88.5 dB sensitivity (Amir measured 88-89dB SPL at 1W into 8 ohms). I sit about 7.5 feet away from the speakers and listen up to 92 dB SPL, but mostly stay between 80-90 dB SPL at my listenin g location.

I have not had power issues. I've never seen a clipping light. I just want more oomph. I've never had a power amp with more power than the 2.5B cubed.

My budget is about $5K. I have been looking at some used 4b cubed amps.

My preamp is a vintage ML No. 38s. Digital from Bryston BDP-3/BDA-3 combo. Analog using Koetsu RS and Shelter 901 cartridges into an SUT (20x) followed by a very vintage Paragon System E used as a phono preamp (I have fully repaired this preamp, particularly the power supply).

I like the sound of the 2.5B cubed. I had a Cary 120 tube amp for some time, but grew tired of the heat and the continuous maintenance, including the insane prices for tubes. I did not experince that great "tube sound" that others rave about. I sold the Cary and went back to the 2.5B cubed.

Will the 4B cubed disappoint?

What other amps should I consifder, new or used?

Thanks for your help!

 

kevemaher

Showing 1 response by 8th-note

8th-note
424 posts
 

I have two suggestions.

1. If you haven't already, try running your Revels full range and let the subwoofer just handle the lowest frequencies. You will need to set its crossover low - around 40 Hz to achieve this and don't run your Revels run through the sub crossover. You may find that allowing the woofers in the Revels to handle lower frequencies improves the punch factor.

2. The 203's are a fairly difficult load for an amplifier. The Bryston is no slouch but it does not increase its power into lower impedances as well as some other amps (Pass, Krell, Martin Logan, etc.). You might want to look for an amp that is rated to 2 ohms or where the testing shows that power increases substantially into low impedances. These amps are heavy and expensive to build which is why most amps don't perform this way.

More to discover