WHAT HAS WORKED FOR YOU? ISOLATION PLATFORMS, FOOTERS, ETC. for a DAC?


What is reasonable to expect in SQ gain with respect to a DAC, since there are no actively moving parts?

Footers only? Platforms only? Or is a combination of both best?

Keeping this open ended (as well as budget wise) to see what Audiogon Members recommend and advise.

However, thoughts on Gains v.s. Spend with the specific products you are recommending are welcome and will be very helpful.

The only footers I have used in the past are those from Herbie's Audio Lab.  I have used two different 'audio' racks (which have been dismantled) and I am using their shelves as isolation platforms for my speakers and other components (but not the DACs).

The DACs in use are a Schiit Yggdrasil and an Exogal Comet Plus. The stock rubber footers with the Yggdrasil are as basic as they come; The Comet has an acrylic plate with rounded metal screws.

THANK YOU!
david_ten

Showing 2 responses by dlcockrum

Hi David,

You are moving in the right direction IMO.

"Soft" footers "cushion" the component from external vibration from the floor/rack but also trap internal vibrations inside the component (isolators vs conductors).

Symposium Acoustics system of combining Rollerblocks with their Svelte shelves (conduct then isolate) drains the vibrations from both the component (on top) and from external vibrations from the floor/rack (from below) into the vibration-absorbing membrane sandwiched between SS plates. Detail and coherence are improved over soft (and hard) footers, cones, and Rollerblocks without the shelves IME

Adding spring devices underneath the Svelte shelves (I use Solid Tech) can improve the sound further for extremely sensitive gear.  

Dave

Right Geoff. I use vibration damping material inside the chassis and stick-on wheel weights on transports/CD players to good effect.

There seems to always be room for improvement in this area.

Dave