Myles, In all cases of which I am aware, the platter of a DD turntable is "part" of the rotor, once it's fastened onto the rotor assembly, or, as in the case of the SP10 Mk3, the rotor and platter come off the chassis as a single piece. This is to say that the mere fact that the NVS platter is part of the rotor does not explain why the platter cannot be removed from the chassis. As some may recall, when the NVS first hit the market there were a few problems with shipping, owing to the fact that the TT shipped with the platter installed. I guess this led to some damaged bearings. But these issues were said to have been resolved. Since that brouhaha, I have not heard much of anything about the NVS.
WAVE KINETICS NVS Reference Turntable
I was having a conversation with a fellow audio lover about tables and there appears to be some mysterious information about this specific table missing so if others could chime in to share some light that would be great.
1. what is the bearing design - link to pics
2. what is the motor and who is it by - link pics
3. provide link to pics of the table with the platter off
4. why does the table come shipped with the platter attached and why can't it be removed
5. who actually manufactures it and where does it get manufactured
6. are pces sourced here and there and just assembled or all from the same manufacture? it was mentioned over seas, is this correct?
1. what is the bearing design - link to pics
2. what is the motor and who is it by - link pics
3. provide link to pics of the table with the platter off
4. why does the table come shipped with the platter attached and why can't it be removed
5. who actually manufactures it and where does it get manufactured
6. are pces sourced here and there and just assembled or all from the same manufacture? it was mentioned over seas, is this correct?