Watts - Volts and Resistance

Herman...Whoops...I divided by 4 instead of 2. (Confused by the quad thing). So it's about sixty watts into 4 ohms, and maybe 40 watts into 8 ohms.

I got this piece for 10 bucks what harm could it make, and it looks as if it's just got out of the factory.
I just hooked it up to a spare pair of sepakers I have, it's not intended for critical listening or anything like it, I think it's future is more decorative than musical. An yes, I can use only two channels if I want to.

Rgds.

El, I agree with your logic but how did you get 133 is 50% of 535?

The 40% of volume is misleading as most receivers of that ilk are going full blast well before the volume control is at 100%. It was a marketing trick to make you think it can play louder than it really can.

Foxtrot, If you are hokking up recievers you may want to see a doctor :>)

As I recall, the Quad receivers from the mid '70's were only good for 20-30 wpc [max] into 8 ohms. Quad was a format disaster, and Quad amps were only produced for 2 or 3 years. You should be able to about double that power into 4 ohms, but bass damping and the amp's stability might be a problem with a 4 ohm load. What are you using for speakers? Do you know their efficiency? Can you bridge the 4 channels into 2 channels?

Thanks for the replies.
I hokked up the receiver(I think it was made in 1976), and beleive me that I'm sure it delivers a lot moer than 20 or 30 wpc. I'm driving a pair of 3 way floorstanders that play loud and I can't get past 40 % of the volume, it's just too loud.
It sounds quite nice for an old receiver !!!

Rgds.

The '535' and '675' must be power-CONSUMPTION amounts. The '4 Ohm Max.' must mean that power compumption is while the unit is delivering maximum power into 4-Ohm speakers.

Those numbers have nothing do to with the audio-power output.

Why not connect it to some speakers and hear if it delivers enough clean-sounding output?
.

The note on the back of the receiver probably says that it draws 535 watts of AC power when it is maxed out driving 4 ohm speakers. This would suggest that its total audio output is probably about 50 percent of 535 watts, which is 133 watts. You say that is a 4-channel amp, so 33 watts/channel would be a good guess.
The 8 ohm audio power will be less...I would guess about 20 watts. All of this would be with all channels driven, so the power capability of an individual channel will be more.