I mounted my TT on a shelf, into the studs. Was great! Then, had new siding installed, and the hammering needed for the siding caused the table and the platform to fall to the floor! Arm broke, other parts broke. Yikes. Fortunately it was repairable, for about $900. It was/is a mofi ultra deck. Just a warning/heads-up for the future. But the studs-mounted shelf solved the feedback problems. Was a rec by Andrew Singer.
Wall mounting on studs
Hi everyone,
I'm mounting my turntable on the wall, and the shelf system is designed to span over 3 studs (and uses all 3). Since my studs in the wall are currently not where I want them to be, I'm just going to open up the wall and install new studs so my shelf can be installed exactly where I want it to be. My question is, should I just add new studs running vertically from floor to ceiling, or can I add 2x4s horinzontally between the existing studs that are 16" apart? I'm not concerned about cost or difficulty - I just want to know from a performance point of view, what's best to minimize vibration to the shelf?
Thanks!
Pierre
I'm mounting my turntable on the wall, and the shelf system is designed to span over 3 studs (and uses all 3). Since my studs in the wall are currently not where I want them to be, I'm just going to open up the wall and install new studs so my shelf can be installed exactly where I want it to be. My question is, should I just add new studs running vertically from floor to ceiling, or can I add 2x4s horinzontally between the existing studs that are 16" apart? I'm not concerned about cost or difficulty - I just want to know from a performance point of view, what's best to minimize vibration to the shelf?
Thanks!
Pierre