VPI Scout with Grado Master - but what next?


I've got an old original VPI Scout with a wood body Grado Master HO MM cartridge on it. I'm using the phono stage in my McIntosh C2200 tube preamp, and pushing the whole thing with a McIntosh MC402 solid state amp. I listen to Jazz mostly.

The Grado Master is about eight years old now, so I'm starting to shop around for a replacement. I had a Grado Sonata in it originally but it was pretty thin and boring sounding and didn't track very well - the Master has been a really wonderful cartridge. However it's a lot better with Jazz than it is with Rock. Rock, even excellent 1/2 speed master recordings, sound forward and lack slam.

So I'd like my Rock to...well rock, but jazz is my main thing, and I'm worried that if I buy a Dynavector or Soundsmith based on recommendations from folks who listen to Rock exclusively, I'll wind up with my Steely Dan bringing down the house, but Leroy Vinnegar sounding like Jack Bruce and a stack of Marshalls. This would be bad. Anyone
lemoco

Showing 3 responses by lemoco

Thanks everyone. I'll look into some mass or a shelf to isolate the TT first, and then have another listen. Any specific recommendations would be much appreciated. I actually had a Graham Slee Era Gold phono stage, but opted for the tube stage in the McIntosh as it has a much blacker background and is much more laid back.

One of the reasons I chose the Grado Master was the high 5Mv output. Looking at the Dynavector MC and the Soundsmith MI cartridges I worry about 2.5mv output requiring too much gain. To be honest I rarely turn the thing up past 4 but I like a lot of reserve power so I came keep the gain down low. Does the difference in output - 2.5mv vs 5mv - really impact the gain?

Thanks Again
Thanks Photo46,

I was looking at this DIY sandbox platform. I have a pretty small house and I can't deal with anymore wires so I'm looking at passive solutions. Perhaps a wall shelf with the sandbox would help.

http://www.cognitivevent.com/sandbox.html