This should be a good match, compliance fits tonearm mass. 100ohm loading seems to be a good match for Dynavectors. I use just a touch of damping fluid, start with just a touch, add more until you start hearing the slightest loss of life, dampening. You want just enough to tame any hardness, shrillness, don't go past this point. Some may not have to use any damping fluid, I use just a bit.
VPI JMW 10.5i and Dynavector XX2 MK II
It seems that perhaps I should have asked these questions first but better late than never I guess. When I try to figure out things like compliance, tonearm mass, loading, etc. I just end up increasingly confused. So I'm on a quest for at least some other opinions.
a) What do you think about the match between this cartridge and tonearm?
b) I have a Sutherland Hubble which has several possible gain and load settings. What would you suggest for gain and load? For "Recommended Load Resistance" Dynavector says >30 ohms. There are a lot of stops along the way between >30 and 47,000.
c) Damping Fluid - Yes? No? Why?
a) What do you think about the match between this cartridge and tonearm?
b) I have a Sutherland Hubble which has several possible gain and load settings. What would you suggest for gain and load? For "Recommended Load Resistance" Dynavector says >30 ohms. There are a lot of stops along the way between >30 and 47,000.
c) Damping Fluid - Yes? No? Why?