2. speakers
  3. 1024942873

Volume Controls that Accept 12 Guage??

I broke down and am buying in-wall speakers for background music driven from my main amp (maybe a new one?) for areas of the house away from my main set-up. After doing some research, I went with 12 gauge KimberKable as the wiring. Whoops!! Despite some serious research on my part I can't find in-wall volume controls that handle anything larger than 14 gauge wire. Oh the humanity !!! That seems to be a bit self defeating but I already spent the money on the wire and had it installed. Please let me save some face here. Anyone know of volume controls that would work??
ozfly
6 responses Add your response
bob_bundus
1,834 posts
 
If your Kimber is stranded cable, as many are, simply cut off a few of the outer strands from the bundle, sizing down until it will fit your L-pad's terminals.
sean
6,231 posts
 
If you are trying to fit the wire into the eyelet on the L-Pad, you can do either of three things.

1) Slightly enlarge the eyelet in the terminal to accept all of the strands.

2) Solder the wire to the terminal without slipping it through the eyelet.

3) Do as Bob said and reduce the strand count on the wire. The small reduction in gauge or conductor size at this point shouldn't make any noticeable difference. Sean
>

rwwear
2,867 posts
 
Most inwall volume controls use terminal strips where there is little room between the wires and the wire can only be stripped a little over one eighth of an inch or it can short out. But if you strip the wire back enough then trim the strands to fit the terminals you can then cut the wires length down so it won't short out. Another remedy would be to make short jumpers out of 14ga. wire and use wire nuts or butt splices to attach the wire togeher.
ozfly OP
887 posts
 
Thanks all for the great ideas. Keem 'em coming though -- if someone knows of a brand that will take 12 ga, it would make life easier. Again, thanks.
rwwear
2,867 posts
 
Well, you could unplug the terminal strip and tack solder the wire directly to the pins.
redwoodgarden
150 posts
 
You can join your 12 gauge wire with a short strip of 14 gauge wire using a wire nut. Electricians use them in homes to join wires together in electrical junction boxes. Make sure that you choose the wire nut color that is designed for joining one 12 gauge wire to one 14 gauge wire. Each color represents different wire size combinations.
Log in to respond
More to discover
80x80
Lansche Audio No 7
80x80
Estelon X Diamond MkII
80x80
Meridian DSP5200HC