I biwired for years, simply because there were two sets of speaker terminals available on my ProAc Response 2s and 3s. Found to my chagrin that single-wiring, using Mapleshade jumpers, sounded noticeably better and cost less. But YMMV.
Using one pair two sets of wires for each channel
Dear Sir,
I just finnished composing my bedroom system with:
Audio Refinement Complete Int.Amp.
Usher CD100
Kimber PBJ
Wharfedale Emerald 99
and
Homemade Speaker cable (13gauge - not terminated)
The amplifier only has one pair of speaker out while the speaker binding posts are bi-wireable (i.e., two pair of binding posts) - With the given configurations, I am trying to bi-wire my system via applying two sets of speaker cables to each channel. As suggested, the amp has only one pair of speaker out so I have to put two sets of speaker cables to one binding post on the amp.
If I am to use two sets of wires for each channel:
a) Is it safe for my amp or speakers (since the wire becomes too thick [13gauge + 13gauge = ... thick!)?
b) Does it improve sonically or degrade it?
Any comment welcome
best,
I just finnished composing my bedroom system with:
Audio Refinement Complete Int.Amp.
Usher CD100
Kimber PBJ
Wharfedale Emerald 99
and
Homemade Speaker cable (13gauge - not terminated)
The amplifier only has one pair of speaker out while the speaker binding posts are bi-wireable (i.e., two pair of binding posts) - With the given configurations, I am trying to bi-wire my system via applying two sets of speaker cables to each channel. As suggested, the amp has only one pair of speaker out so I have to put two sets of speaker cables to one binding post on the amp.
If I am to use two sets of wires for each channel:
a) Is it safe for my amp or speakers (since the wire becomes too thick [13gauge + 13gauge = ... thick!)?
b) Does it improve sonically or degrade it?
Any comment welcome
best,
6 responses Add your response