2. cables
  3. 1092405587

UPgrading power cord for Audioprism Foundation III

Can any of you suggest a power cord upgrade you have experience with in regards to link from an Audioprism Foundation III to wall outlet. The female end takes a horizontal blade 3 prong. I can't decide on whether to go with a very heavy duty cord like the PS audio LAB or something with a lighter gauge like those used for preamps or source equipment. All outlets on the conditioner are full and I'm running 2 amps into it and 4 source pieces. THanks in advance. Dave.
canucks0
2 responses Add your response
danlib1
819 posts
 
Dave-

For my Foundation III, I switched to a 1 Meter PS Audio LABII cable, 20 amp IEC of course, and found the results quite nice.
monk
120 posts
 
Dave, I'm not sure what your system is, so I will only comment on my system and experience here.

I had a TREMENDOUS upgrade going from the stock AudioPrism cord to a 20amp (female end) to 15amp male end Tg Audio SLVR! Huge upgrade to my entire system. Every component is upgraded. I would do this before adding/upgrading any other cords in your system. For me it was huge. Also, think about replacing the wall outlet to a 20amp outlet as well. I used a Acme audio 20amp cryoed - again the whole system benifits - bigtime. Better than upgrading some components here.
Log in to respond
More to discover
80x80
Burson Audio Soloist 3X Performance Dac
80x80
ANTICABLES Level 3.2 Reference
80x80
Shunyata Research Omega XC V2 C19 20A