Upgrade capacitors in tube amplifier?

I really like the internal wiring on that tube amp. Very neat and organized. 80% point-to-point except with the few pcb boards and thicker wire than a lot of more expensive domestic amps.

My thoughts on the cap upgrades is to not do it unless you hear something you think is deficient and you have already upgraded the tubes and interconnect cables.

If you do upgrade just do the coupling caps connected to the tube sockets and realize a speaker crossover environment is very different from a tube amp. Make sure the capacitors are rated for higher temperatures as well as higher voltage.

What make is that tube amp?

After looking at the Willsenton web site I see that they use generic EL34 tubes stamped with their Willsenton name. (I'm sure Willsenton is not manufacturing tubes.) At that price point they are likely not higher quality tubes. Even expensive tube amp manufacturers often use "budget" tubes expecting the buyer will roll them to higher quality tubes.

So if you haven't already done so I would recommend two matched pairs of Tung Sol EL34's and also upgrade the 12AX7 and 12AU7 vacuum tubes.

@chinook9

" 1extreme, I realize the circuitry is very different. Generally, do you think there is less potential for a coupling cap upgrade to be as effective as a crossover cap upgrade?"

The answer to that really depends on the other components in your tube amp and the other audio components in your end-to-end audio chain. Do you believe those two coupling caps are really the weakest link in your end-to-end chain? If not then it is unlikely that any improvement would be "revealed" by your system. BUT....this is also about having fun so if getting in there with your soldering iron and swapping components and trying to hear the difference will bring you fun then go for it. Been there and done that, so I’m the last one to poop a fellow audiophiles party.