upgrade cables

Hi Steve:

Before switching to the QED Silver Anniversary speaker cables, I was using Signal Cable Silver interconnects and speaker cables. The system was comprised of the same Outlaw receiver and the speakers were either Rega Aras or NHT SB2s. The sound was screechy to say the least ... the highs were sharp and bright. The culprits were the speaker cables as once they were swapped out, the system sounded fine.

Rich

Sgr,
I began with Signal Cable Silver Resolutions between my CDP and an integrated amp that I do not have any more. With that, I had the Nordost 4 Flat bi-wires for my speaker cables. The Silver Res had replaced the Nordost Blue Heavens (on loaner from the dealer who sold me the CDP), that I found were very bright in my system. Being impressed with the Silver Res RCAs, I simply went ahead and purchased the Silver res speaker cables. I did not consult with Frank on that. But I am more than happy that I replaced the Nordost 4 Flats with these. They reveal a lot of information without sounding bright, in my system.
I am not sure if Frank can provide loaners on the Ultra that you mention. I would like to try and find out how that combination would work in my system. BTW, all my cabling is from Signal Cables - been pretty happy with them.

Thanks,

Hi all, i have upgraded all the power cords to Pangea Ac-9 and 14 for my Amp, Preamp and Speakers, i would like to know should i put my Pangea Power cable into wall outlet or plug into my Monster power conditioner?