Tube Amp for Coda 8 Part 2

I kinda went through this same situation last fall. But with different equipment. I sold my pre amp and amp and got a new Coda 5.5s. At that time I had a Denafrips Venus II DAC I bought new in 2021. That DAC fed my Legacy Audio Wavelet II which I then used as a preamp for volume control. The Wavelet also works as an outboard crossover/DSP room correction unit sending the mid/top to the Coda and the bass to the internal amps in my Legacy Audio Focus XD’s. I was considering getting a nice Tube pre amp such as the Aric Audio Motherload II or the new Spatial Audio Raven. I researched as much as I could to find at what level the Wavelet acts as a quality Pre amp and weather a pre amp prior to it would make a noticeable difference.  I was so close to getting the Raven but a conversation with a dealer convinced me to not do that with only 1 input needed (from the DAC) and add more stuff in the chain, another high cost interconnect and power cord. He convinced me to keep it simple and for go all that. So, I decided to instead get a better DAC and ended up with the new Denafrips Terminator 15th. I am happy with the sound I get. But I too still struggle with the curiosity if injecting a pre amp into the chain will make a significant difference too. It would be a very expensive experiment so I can’t really try it. Legacy presents all it products at shows using just the Wavelet even in their $80,000 top speaker system with good results so it can’t be too bad. So that’s my logic. Your DAC is very good and keeping the chain simple may bear quite good results but you have to satisfy yourself. Good luck on your journey.