SME III´s very low mass hyper rigid titanium-nitride armtube is damped by teak strips, a small oil reservoir under linked to armtube adds extra damping if necessary. SME III is a superior performer with high compliance carts, with oil or without depending on a cart used, IME since 1987. I think it can get the best out of any HC cart, and it works nicely with lower compliance carts as well due to adjustable counter balance system (thin lead plates). Obviously designed especially for HC carts. A classic SME at finest.
Tonearm recommendation
Hello all,
Recently procured a Feickert Blackbird w/ the Jelco 12 inch tonearm.
The table is really good, and its a keeper. The Jelco is also very good, but not as good as my Fidelity Research FR66s. So the Jelco will eventually hit Ebay, and the question remains do I keep the FR66s or sell that and buy something modern in the 5-6 K range. My only point of reference is my old JMW-10 on my Aries MK1, so I don't know how the FR66s would compare to a modern arm. So I'd like to rely on the collective knowledge and experience of this group for a recommendation.
Keep the FR66s, or go modern in the 5-6K range, say a Moerch DP8 or maybe an SME.
Any and all thoughts and opinions are of course much appreciated.
Cheers, Crazy Bill
Recently procured a Feickert Blackbird w/ the Jelco 12 inch tonearm.
The table is really good, and its a keeper. The Jelco is also very good, but not as good as my Fidelity Research FR66s. So the Jelco will eventually hit Ebay, and the question remains do I keep the FR66s or sell that and buy something modern in the 5-6 K range. My only point of reference is my old JMW-10 on my Aries MK1, so I don't know how the FR66s would compare to a modern arm. So I'd like to rely on the collective knowledge and experience of this group for a recommendation.
Keep the FR66s, or go modern in the 5-6K range, say a Moerch DP8 or maybe an SME.
Any and all thoughts and opinions are of course much appreciated.
Cheers, Crazy Bill