2. analog
  3. 161721-10840

Tone arm holes do not line up - best way to attach TT?

I bought a new Reed tone arm (3p 12" Tonearm Ruthernium) and the holes do not line up on my Haas table. I'm new to vinyl ... can I attach it with double sided tape? I can use silicon which is strong and can be easily removed? Or, does this approach negate the dampening of table? I've  gone to great lengths to isolate with a rack, spikes and 3" thick maple slab that the TT rests on. What is the "normal" way when that happens? Thanks in advance. 
mcmanus

Showing 2 responses by cleeds

cleeds
6,118 posts
 
mcmanus
... My pivot to spindle distance is correct according to the template that came with the Reed. I mentioned the 6" away from the TT to indicate how far away the arm would have to be to fit into the alignment grid ...
Something is just not right. If the pivot-to-spindle distance is correct, then it should allow you to properly set the overhang, by definition.
cleeds
6,118 posts
 
mcmanus
Any ideas on cartridge alignment? I spend an hour on forums and youtube and no one addresses the issue when the alignment falls outside the ability of the arm head-shell to adjust.
Your alignment issue is the result of an improper pivot-to-spindle distance. That's what needs to be corrected.
More to discover