2. cables
  3. 1368791678

To splice or not to splice?

I have a mid-fi system (Dynaudio MkII, NAD c320BEE, Canare wires) and recently acquired a 6-foot Audioquest King Cobra cable for next-to-nothing. My first inclination was to cut it up to make a pair of extremely short IC's to replace my pre-to-power amp jumpers and then to make one or two pairs of short IC's for component-to-pre connection.

I have since become aware that the King Cobra has connectors which are welded, not soldered. I'm not concerned about losing value as I have little in the cable and do not plan to sell it. I am concerned with losing a high percentage of sound after splicing and adding standard audio RCA connectors using solder.

I expect a small loss from the process. Am I likely to be disappointed?

Is there anyone here with some experience in this realm?

many thanks,

T.U.
128x128tostadosunidos

Showing 3 responses by zd542

zd542
5,339 posts
 
I don't know if your current system has enough resolution to benefit from all that work. Try using the cable from a source to your NAD and see if it makes a difference over what you are currently using.

Either way, if the choice were mine, I wouldn't cut it. Its a great sounding cable. Just use it in your system the way it is, and enjoy it.
zd542
5,339 posts
 
Sorry. I didn't realize you only had 1 actual cable. Since were are talking about IC's I just naturally thought one pair. You definitely did the right thing by listening to it and confirming a difference. There's only one thing left for your to do: Chop! Have fun, just watch your fingers.

One last thing. If you are planning to use the 2 original factory terminated RCA terminals, make sure that use use them in the exact same application. For example, if you make a pair of IC's, you'll have to add a connector to each piece. When you use the cable run the like RCA's together and not at opposite ends. Needless to say, if you make more than 1 pair, keep the originals together in 1 pair. Anyway, I'm sure you would have figured all this out yourself, but it doesn't hurt to be careful.
zd542
5,339 posts
 
"Zd542, wouldn't it be the opposite? One of the original RCA's has the arrows pointing in, the other out. So I think one should be in the preamp, the other in the source component or in the power amp (if used as jumper). Right?"

No. The arrows are for the cables themselves, not the connectors. They are used for break in. You can run them the other way, but it will just take a little longer for the cables to re-break in for the change in direction. If you are making a pair of IC's or jumpers, you want them exactly the same.
More to discover