agree with trial and error. i added some jm reynaud cantabile speakers to my system and found some big differences in sound with how i wired them. this was the first bi-wire speakers i've had, and had no idea on the best way to set these up. first round was using a single wire cable from the amp to the high frequency connections on the speaker with the factory jumpers to the low frequency terminals. the sound was extremely bright and fatiquing. after 2 days, i switched the single wire cable to the low freq terminals with the jumpers in place for the high freq terminals. this was much better- more bass, very enjoyable sound. due to the differences i discovered, i decided to bi-wire them and found even more improvement. more clear, with a more balanced sound.
To biwire or not to biwire, that is the question??
Thanks for taking the time to read. I have sifted through the mound of information regarding biwiring but have yet to come to a clear yes or no on the matter.
My question is as follows: Using a single 2CH amplifier run to speakers that are set-up to biwire utilizing a biwire cable (2 connections amp end/ 4 connections speaker end)should return no greater result than running a single wire to that same speaker and utilizing jumpers??? My reading suggests that unless you are bi-amping, simply taking the source of the signal at the amp, (2 connections) and splitting that into (4 connections at the speaker) is not positively affecting the sound?? Bi-amping on the other hand may return an improved sound as the signals are isolated and could affect the resistance of the load?
So I guess what my reading has indicated is that if you are only running a single amp (2 connections) to a bi-wire ready speaker (4 coonnections) you are really paying for a cable that has additional ends but should return no great end product as the signals are technically not distinct as in the case of using 2 ampsor an amp set up for bi-amping?
Any thoughts are welcome as this seems to be an endless debate???
My question is as follows: Using a single 2CH amplifier run to speakers that are set-up to biwire utilizing a biwire cable (2 connections amp end/ 4 connections speaker end)should return no greater result than running a single wire to that same speaker and utilizing jumpers??? My reading suggests that unless you are bi-amping, simply taking the source of the signal at the amp, (2 connections) and splitting that into (4 connections at the speaker) is not positively affecting the sound?? Bi-amping on the other hand may return an improved sound as the signals are isolated and could affect the resistance of the load?
So I guess what my reading has indicated is that if you are only running a single amp (2 connections) to a bi-wire ready speaker (4 coonnections) you are really paying for a cable that has additional ends but should return no great end product as the signals are technically not distinct as in the case of using 2 ampsor an amp set up for bi-amping?
Any thoughts are welcome as this seems to be an endless debate???