2. speakers
  3. 1247245568

To Bi-wire or not?

I was using Tara Labs shot-gun cable to connect my Usher speakers, leaving the jumpers in. When I switched to Blue Jeans cable and true bi-wire and removed the jumpers. I hear no improvement, in fact i lost some bass. I contacted Blue Jeans to see about cable burn-in but they said burn-in is a myth. I have heard that bi-wiring a speaker with low end cable is better than using higher quality cable in non bi-wire application. Any thoughts?
tbromgard

Showing 1 response by daveyf

daveyf's avatar
daveyf
3,004 posts
 
Tbromgard, as you using two seperate cables per speaker?
If so, are you sure that the connections are in correct polarity at the amp and the same at the speakers?
Also, I find it very helpful to make sure that the routing of the cables is as direct as possible without too much parelleling if possible.
More to discover