The new Coda S5.5 amplifier: It's a "Petite Beast"!

But at 4 ohms the amp is still running in class A up to around 40 watts. AB would then kick in over the 40 watt threshold.

Channel reversal?

I've been in this hobby for decades so owned or auditioned many amps.  I've seen it both ways, logical from the front of the amp and logical from the rear.

But really, the labels are for convenience, you can wire up either way, just so the L/R speaker outputs match the input channels.

If this confuses you maybe you're a candidate for mono blocs?  ;^)

@aolmrd1241 

          Thank you Mark! Yes agree and I should have made that clear. The S5.5 is still giving Class A into 4 ohm and likely lower impedances too but at power below 50 watts. Even 40wpc Class A power is excellent though because that should suffice for most speakers unless the speaker is really tough to drive.

I was looking for an integrated and bought my CSiB in 2023 and really like it. I know the S5.5 would sound better but they each have their pluses.  The CSiB is V-1 so the first 18wpc into 8 ohm is  Class A. It is 150wpc 8 ohm/300wpc 4ohm/600wpc 2ohm all AB. I still get some Class A at 4 ohm but maybe 9wpc or less which is good enough for an 8 ohm Forte 3 speaker. It drives LRS+ superbly but is all AB and the high current is key.  If I feel I need or want another amp though, the S5.5 is definitely my number one choice! Teajay and this thread are very convincing! I just hope Coda doesn't run out of those magic transistors.  

@jetter 

         Thanks for your kind words. I have been into audio for 50+ years and am still an amateur. I know just enough to be dangerous. I am certain any electronic engineer in the group can pick this apart; however, I think it gets the general idea across. And again, it's not worth a hill of beans. The sound is what counts. So here is additional clarification jetter. At least I hope it is clarification. 

           You are partially correct, but as Aolmrd commented, the Class A S5.5 amp does produce Class A audio at impedances actually below and above 8 ohms but with different power ratings, typically below the AB power ratings especially for lower impedances such as 4 ohm and lower. The following example is strictly  for illustration only; the actual WPC values stated are not to be taken as fact but for illustrative purpose only. This shows why, whether the amp is called AB or A, that it can exhibit both classes depending on its electronic architecture, driver impedances, and current potential. This illustration is for the S5.5. 

1) Class A, 8 ohms, up to 50 WPC;  above 50wpc into 8 ohms is AB; For lower impedances above 50 WPC --->Class AB, 4ohms up to 100WPC AB,  2ohms up to 200wpc AB. 

2) Class A, 4 ohms, up to 40wpc; above 40wpc into 4 ohms is AB

3) Class A, 2 ohms, up to 15wpc; above 15 WPC into 2ohms is AB

S5.5 is called a Class A amp based on 50wpc Class A into 8 ohms but you can see it's more complex than that. However, a 50WPC Class A amp hints of being a great sounder! Terry London clearly pointed out the S5.5 does more than hint, it shouts. Terry led the AGON band and all the musicians in the band were precisely in tune!

S5.5 is a winner! In any Class!