Technics SL1200 Cardas REWIRE Shielding

The cardas will make a big difference, but you can not used shielded wire in the arm; too stiff. I would not mess iwth it. Box up the table or the arm and send to KABUSA dot com; and let Kevin do the re-wire for you. Can not speak highly enough of him.

best

I hear you KAB is amazing, no question. But I want to do it myself, learn something new, and enjoy the process. It is going to be tricky working with these slim wires but I will try to sort it out. Thanks guys. It is too bad the tonearm wire, when shielded, will not fit through properly, I would have liked to have the entire run shielded.

Nonetheless there is still a problem, supposing that I could pass the wire through the wand shielded, what do I connect the shield to?, if I run the shielded portion through the base only I am still curious as to where to connect the shield.

A further thought, some headphone wires would pass nicely and then I could have an entire run of shielded wire passing through the tonearm and base. In this case the ground connection becomes easy, since the headphone wire has left signal +l sheild and right signal +r shield they could be connected directly to the cartridge 1 to 1.

The metal tonearm tube is your shield.

No shielding needed for the wires in the tonearm.

Yeah. The metal arm tube is your shield. If I were rewiring a Technics arm and wanted to thread something through the wand with it, it would be vibration damping.

Lacking that, I wrapped teflon plumber's tape around the outside of the armtube.

Your guys are right, wand is the shield. Ground is soldered to end of wand, inside the tube. and follows itself down into base. Thanks guys. Recently switched to a VPI HW19 and I am loving it.