2. analog
  3. 168608-2383

systemdek IIX motor stopped working

I was playing a record and it ground to a halt.  I took off the platter and the motor is def getting power I can feel it vibrating but it's not spinning.  The Platter spins very smoothly without the belt attached.  Any obvious thing to look for here?  Maybe just needs a new motor? Thank you. 
128x128ejlif
7 responses Add your response
ejlif's avatar
ejlif OP
1,370 posts
 
I took the motor out.  Seems like the pully needs to come off the spindle to get inside the motor.  Looks like it's pressed on not sure how to this is supposed to come off?  
dekay's avatar
dekay
5,556 posts
 
Here are a couple of threads regarding your deck.

In both cases I think is was a bad motor run or start cap.

https://www.diyaudio.com/forums/analogue-source/131416-motor-systemdek-llx.html

https://www.vinylengine.com/turntable_forum/viewtopic.php?t=54650

DeKay
Post removed 
ejlif's avatar
ejlif OP
1,370 posts
 
There is a little bit of resistance not much if I spin the motor shaft by hand, it won't spin freely but it does turn fairly easily just won't coast on it's own after spinning it.  The platter will spin for a while it is very smooth
  

mijostyn's avatar
mijostyn
8,570 posts
 
Can you spin the shaft/pulley with your fingers? If it spins freely you have to look for an electrical fault. Electric motors are very simple, not much to go wrong mechanically other than bearings in which case you won't be able to spin the shaft or it will grind for you. 
Ag insider logo xs@2x
cleeds
5,947 posts
 
Maybe the motor just needs a drop or two of oil.
Post removed 
Log in to respond
More to discover
80x80
Pro-Ject RPM 10 Carbon
EVOLUTION - Performance and Beauty Merge
80x80
CHOIR AUDIO Turntable with SME 3 tonearm
80x80
Rega Planar 8 (P8) with Apheta 3