@mulveling , The advantage of making your own cables is being able to keep them as short as possible. If you use a high bandwidth balanced cable like Canare Da206, use the two inner connectors for signal wires and connect the shield only at one end ( I usually use the load end), you will have a better cable than you can possibly purchase. You will also save a pile of money which you can spend on music.
SUT Interconnects
What cables have you tried between an MC SUT box and 47K MM phono stage? What was your favorite?
I’ve tried the AudioQuest upper-line "normal" ineterconnect cables (Sky, Fire) - great cables in other slots - but very colored coming out of a SUT. Not great performance. I assume that at 1.0m+ lengths, their capactitance is far too high for this application. I’ve tried 0.5m runs of Wind & Niagara (a bit lower in their "normal" IC line, slightly smaller guage wire and less shielding to boot) and got better results. However, my best results by far are with a 0.5m AQ WEL Signature LP phono cable (optimized for low capacitance phono applications). I’ve also tried the Bob’s Devices custom cables, 0.7m, both copper and solid silver versions - these have good performance (particularly the silver), but are more on the level of the 0.5m Niagara, still short of the WEL LP.
The problem I have is that the WEL LP is quite spendy, and I want a 2nd good SUT cable for a 2nd arm & SUT setup. Looking for more reasonably priced options. I’ve had excellent results with a Synergistic Research Foundation phono cable on a tonearm (DIN plug), and wonder how a short all-RCA run of it might do off a SUT (also interested in the Atmosphere X series). Any experience with SR or other cables off a SUT would be appreciated!