2. analog
  3. 1335275711

Surface noise

I seem to have noticeable "noise" in between tracks on vinyl, especially at louder volumes. Should I try adjusting VTF? The system is a Luxman PD-441 turntable, Denon DA-307 arm, Grado Gold cartridge. Everything is pretty well isolated from vibration on a sand filled stand which is on floor spikes and the Luxman is sitting on vibrapods. VTF is probably near 2 grams right now. Thanks for advice.
bdunne

Showing 1 response by jragsda

jragsda
18 posts
 
I suggest you test azimuth. Use the Cardas LP or similar with 1khz through the left and then right channel. Listen for crosstalk in the opposite channel. If one channel has more crosstalk, do the following. Using a hole punch, punch out a small round shim. Place this shim on the side of the cartridge opposite the weak channel.

Sorry, the Bordeaux calls must go now.
More to discover