Does your sub operates with other sources. You might have to set it up with a test DVD such as Video Essential or on some movie or concert DVDs there is a THX optimizer chapter with audio test tones.
Good luck.
Rich
Good luck.
Rich
Subwoofer problem
Help!
I have problem with my B&W ASW 800 subwoofer with Rotel RSP1068. Just started not working. Both of them are brand new.
Just want to try more before I bring it to place where I bought since subwoofer is so heavy.
When I do the speark Test Tone from Rotel 1068 processor, there is no sounds in subwoofer, all other 5 speakers are fine.
But when I switched off the subwoofer for a while then turn back on it, hear a sound for a second then nothing. However not everytime I turned it off/on again, just sometimes it works momentariy but not always. so I think it's not the cable I think. Also I see green light at the backside so power is o.k.
Thse are my subwoofer settings,
Volume:12 o'clock position.
Mode: ON
Phase switch: 0
Low-pass filter: OUT
Low-pass frequency: irrelevant(use for home theater) but I set it somewhere between 80~100hz
Rotel RSP1068 processor settings,
Speaker setup: small to all (Front, Center, Rear)
subwoofer: Yes
leave dB as 0 (default)
So Can you tell me what I can do to diagonosis?
I'll really appreciate any feedback.
Thanks.
I have problem with my B&W ASW 800 subwoofer with Rotel RSP1068. Just started not working. Both of them are brand new.
Just want to try more before I bring it to place where I bought since subwoofer is so heavy.
When I do the speark Test Tone from Rotel 1068 processor, there is no sounds in subwoofer, all other 5 speakers are fine.
But when I switched off the subwoofer for a while then turn back on it, hear a sound for a second then nothing. However not everytime I turned it off/on again, just sometimes it works momentariy but not always. so I think it's not the cable I think. Also I see green light at the backside so power is o.k.
Thse are my subwoofer settings,
Volume:12 o'clock position.
Mode: ON
Phase switch: 0
Low-pass filter: OUT
Low-pass frequency: irrelevant(use for home theater) but I set it somewhere between 80~100hz
Rotel RSP1068 processor settings,
Speaker setup: small to all (Front, Center, Rear)
subwoofer: Yes
leave dB as 0 (default)
So Can you tell me what I can do to diagonosis?
I'll really appreciate any feedback.
Thanks.