Speaker positioning: why do audiophiles neglect this so much?


Went to a recent seminar featuring Jim Smith, well known author of the book  "Get Better Sound"  and hi fi set up guru.

The basic gist of the discussion was that the most important elements of a high end stereo installation are listening position and speaker positioning, in that order.  The actual hardware (speakers, amplifiers, source, cables etc) are of less importance relatively speaking.

Yet it is clear from this web site and it's contents, that set up is discussed much less than the actual hardware.

When I look at the Virtual Systems page on site, I'm estimating that, maybe, 10% of the systems posted are close to well set up.  Thus, hardly any of the featured hardware is performing close to it's maximum potential.

Shame, and why is it so?  Not sexy enough to talk about system set up in depth?  Lack of knowledge?  Or is it simply too hard to do and too complex a subject?

Just my 2 cents ...

bobbydd

Showing 1 response by tim_p

I always adjust/measure my 2 channel speakers by toe in and measuring distance to the "old" sweet spot, plus distances between speakers, the back wall, side walls, from audio rack etc, and once adjusted they stay put. My Monitor Audio Platinum PL300ii are a pain to tweak/adjust at 120lbs a piece. 

Even my HT speakers are all the same height off the floor mounted on the wall.