2. cables
  3. 1050965715

Speaker Cables? Your input kindly requested.

I am upgrading my system, its the speaker cables turn.

Source: Sony dvpns900v
Preamp: Rotel rsp-976
Amp: Bryston 4b-st
Speakers: B&W cdm9nt
Interconnects: Transparent musiclink 100s

I have just listed the 2 channel components, it is my primary concern. This setup is part of a 5.1 system. I listen to 90% 2 channel, 10% movies.

Anywho, I am using Transparent Wave 100 speaker cables (non-biwire). By my taste, the sound is a bit harsh, or maybe forward, in the upper mid.

I want to upgrade my speaker cables(probably to bi-wire).....any suggestions???

As you can probably tell from the equipment, I am budget restricted, say maybe $500.00.
distortion

Showing 2 responses by rsbeck

rsbeck
887 posts
 
If you gave me that system and five hundred extra dollars, I would upgrade those speakers. For my
money, B & W have a tendancy to sound "bumped"
in the upper mid. Sounds great in the showroom,
but less so at home. B & W CDM 9 NT's are not a
bad speaker, but on your way up the chain, I doubt
you'll be satisfied with them. IMO, trying to use wire
and cable to push those speakers to where you
want them is pounding a square peg into a round
hole. Save the wire and cable money and put it into your speakers.

Just my opinion.
rsbeck
887 posts
 
Here's a great place to get speaker wire and patch
cables...

"http://www.partsexpress.com/webpage.cfm?&DID=7&WebPage_ID=40"
More to discover