You picked good cable with the 4S11 but there is a lot more to it than gauge. At higher frequencies inductance will dominate over resistance. The 4s11 is good in this respect. Worst case use 2 runs to half impedance. People go gaga over damping factor but cable runs are normally a very small fraction of voice coil resistance and other impedances in the cross over. Inductance at high frequeny of the cable can be impactful speaker dependent.
Speaker cable length
Hey y'all,
I'm thinking about changing the setup of my rig so the equipment rack is off to the side and nothing is between the speakers. However, that's going to entail a much longer set of speaker cables. Is there anything about speaker cable length I should be aware of? And and am I right in assuming that I need to keep both pairs of cables equal length?
I'm thinking about changing the setup of my rig so the equipment rack is off to the side and nothing is between the speakers. However, that's going to entail a much longer set of speaker cables. Is there anything about speaker cable length I should be aware of? And and am I right in assuming that I need to keep both pairs of cables equal length?