Sorry - a couple more newbie analog questions


I did a search on this but couldn't find answers pertaining directly to my situation so here it goes...

Stupid question #1) When changing records should I turn the player off, or can I change on the fly? My paranoid half is telling me that I might be damaging the other side of the record and/or the motor. I am not using a clamp.

Stupid question #2) When a cartridge is still breaking in what ways does it sound bad? I am noticing sometimes, not always, high frequencies distort - high, loud, short piano or violin notes. Is this normal break in or do I not have the cartrdige set up properly. (Goldring Elektra/Rega RB250) The VTF is set at the top end of the suggested range, 2 grams. The cartridge is factory pre-set, when I checked the alignment with the paper thingy it looks okay. Could this distortion be a software issue, most of my lps are pretty old and I am still waiting for my disc doctor kit. The cartridge has about 20 hours on it.

Thanks in advance!
tooter

Showing 4 responses by slate1

First of all - there are no stupid questions, only stupid people. I can safely say you don't fall into the latter category by the simple fact that you've taken the plunge into vinyl!

That being said, if your turntable doesn't have a "sticky" mat made out of rubber, etc. it's perfectly fine - in my opinion - to change the record side without turning the table off. My table (a Rega P5) has the stock felt mat on it and I leave the motor running during an entire record playing session - it's easier on the motor and if you're records and mat are clean you should have no problems.

The other problem you're having I'm inclined to say is probably software issue, but I'll be curious to hear what others have to say about it. I've got a couple of discs that this happens on too with my Rega Exact cartridge and I'm fairly certain it's the pressings since it's not consistently a problem.

I was originally concerned that the Exact cartridge could have been overloading my phono-preamp and causing the distortion but have since learned that the phono-preamp has plenty of headroom to accomodate the cartridge. This might be something you want to check on though since the Goldring cartridges are very high output MM's as well.

The only other suggestion I would have would be to keep playing to a minimum if the records are dirty until you get your cleaning supplies.

Have Fun!
I wouldn't try switching LP's without turning the motor off with the Herbie's mat in place.

One thing you can do to really help out the motor and, especially, the belt life is give the platter a light spin with your finger before turning the motor on. A majority of the stress a motor undergoes is when it's trying to get that heavy platter up to speed from a dead stop.

The Goldring table is basically a Rega P2 table isn't it? If memory serves it's got the RB-250 arm on it. I would think that Goldring would make sure the VTA is correct with the Elektra. Interestingly enough - that's the same cartridge that was on my first "better" turntable, a Music Hall MMF-2.

Maybe some others have got the same Dylan LP's you've got and could check to see if it's in the pressing. One of the LP's that I've recently listened to that had this problem was a newer 180g pressing of an early Black Sabbath album (keep your comments to yourself please....)during a sustained very loud bass note.
A great deal of stress that the motor undergoes is in getting the platter up and spinning from a dead stop. With a belt-drive table 99% of that stress can be alleviated by simply give the platter a light spin with your finger prior to switching the motor on.