Actually upon looking again there are GAE Alu rep armboards
on the UK Ebay site sold by several vendors.
on the UK Ebay site sold by several vendors.
SL1200G GAE Arm Board
Anyone know how thick I would need to make a replacement arm board for this table.
I have a template for the design and size just do not know how thick or deep in mm.
I need one that is flush with the top of the plinth.
I have not been able to source one from any of the suppliers I could find which are
mostly overseas. I did find a guy that would make one out of wood but I would like
one out of aluminum to match the top of the table.
I have found on line mfg's of aluminum parts.
I have a template for the design and size just do not know how thick or deep in mm.
I need one that is flush with the top of the plinth.
I have not been able to source one from any of the suppliers I could find which are
mostly overseas. I did find a guy that would make one out of wood but I would like
one out of aluminum to match the top of the table.
I have found on line mfg's of aluminum parts.