2. tech-talk
  3. 168798-42403

Signal Degradation Balanced Output

Has anyone developed a workaround that solves signal degradation when splitting. The problem that I have occurs even when the preamplifier has two balanced outputs.

Years ago I became aware of this problem when using my Sonic Frontiers Line 3, which has 2 pairs of balanced outputs, to drive a Theta Dreadnaught amp and a pair of Entec LF-20 subs. I thought the sound was excellent until oneday, I disconnected the cable to the sub and that’s when I heard what I had been missing from the Wilson Cub I, transparency and reverb that allows you to hear deep into the music.

Now, I’m running Focal Mini Utopia Be, Denafrips T+ DAC to Athena Pre, which has 2 pairs of balanced outputs driving a ARC VT-130 and a Focal Sub6. Same problem! I’ve tried inserting my Jeff Rowland Model 112, then tapping off the speaker terminals with a Jensen ISOMAX transformer which then goes to sub.. the problem persists.

The problem isn’t huge, it’s just that the higher the resolution of the components, the more noticable it is. My setup needs the lower fundamentals that a sub brings, but at a cost I’m not happy with.

Any ideas?




cathy062

Showing 2 responses by pauly

pauly
1,012 posts
 
You could look into using an active crossover between your Athena and ARC&Focal. 



pauly
1,012 posts
 
I suspect your ISOMAX is creating a different problem than the one created by  employing your pre amp's two outputs simultaneously. 

As you correctly concluded a few posts up, your ISOMAX is not a product one can associate with audiophile quality sound. Whether you apply it to a line level signal or an output level signal, nothing good is going to come out of it. Your idea is sound, but you need to step up to a product that is substantially better (and sadly, much more expensive).

Active crossovers present the same dilemma - the vast majority (all?) of them are complete junk and sound terrible. I believe Bryston made a hifi quality crossover but I could never track one down to try.

I think there is value in considering that the combined (i.e. lowered) input impedance of your ARC and Focal makes the Athena unhappy, but I'm at a loss as to how you would test that. 

In your shoes, I would probably roll with a set of full range floor standers and junk the sub. Not a cheap solution but the safest I would think. 




More to discover