Should I need a pre amp for one source?
I just purchased a Cary DMS 600 streamer/player/dac. It replaced an Aurender A10 player and a Linear Tube MZ 2.0s pre-amp with all the upgrades and the Cary sounds much better than the combo just as a stand-alone .
i have always had pre’s in my system with streamers/ Dacs because the digital volume controls usually leave a lot to be desired
The Cary seems to get it right. But you know.... was thinking of maybe a passive volume control? Just don’t want to spend 3K on a pre> upgraded power cord and another set of interconnects.
Please talk me off the edge of the rabbit hole
~Russ
benzman OPMines only $525aud = ($354usd) posted, and that’s with the price rise, I still think and been told it’s way to cheap. If your able to use a soldering iron you can adapt this remote volume control to it for only $24usd. https://www.ebay.com.au/itm/Assembeld-Remote-volume-board-HIFI-preamp-motor-ALPS-100K-potentiometer-L165-11/142347424572 Cheers George |
benzman OP Good idea that way you don’t run the risk of bit stripping if the digital domain volume control is under 75% of full. (But if higher than 75% I would still go direct for the very best). The Cary with it’s volume up full is 3v available at 200ohms, all you need is a good passive as tgrisham mentioned, the Odyssey only needs 1v in to make it clip full output, so no need for anymore gain, noise, and coloration/distortion that an active preamp brings to the equation. Remember what Nelson Pass said: (this’ll get a few backs up again)
Cheers George |
Yes it drives my Kismet Monoblocks nicely. I just like to leave the digital sources at 100 and let the pre take care of volume while increasing the voltage. Funny my goal all along was to get rid of a pre in the chain. I had a Gold Note DS-10 which is a Streamer/dac and analog pre, but just didn't cut the mustard. Very good for 2500 but not in the league of the Cary. I had a Musicbook Source on order, which is a Streamer/dac with an analog pre but they took to long to get it to market. I guess I am hung up on the "digital" volume control figuring I am losing bits at lower output. Thanks for the advice. I am building a dedicated room and will take the 3k and invest in a wall system which will probably make a much bigger difference for the $$$ |
benzman Your Cary has up to 3v output from a nice low 220ohm source and it has a volume control just do a direct to amp connection for the most transparent/dynamic sound you can get, any preamp will detract from these and add coloration/distortion. From Cary: DMS 600 has full 3-volt output and variable volume control for direct-to-amplifier connectionCheers George |