Setting Sub Crossover Freq

Thanks very much. I see that if you roll the freq back, you sort of need to roll the volume up...

THANK YOU.

80HZ, I like this...this is the Ron Popeil solution: set it and forget it.

Does the software require much in the way of miking, etc ?

Thanks all for your input. I the case of polarity...I'm having trouble. Is there a precice way to know, other than by lisening for "more bass" ?

Dgaarretson, I am running RCA outs from my pre into the RCA inputs on the Sub. (I'm running balanced from the other pre outs to my amp, which is then powering my speakers--full range).

Thank you !!

I have set it to about 50-55 on the low end, althoug it's tought to tell with the rotary dial and now the volume is at about 2 o'clock. Seems to been pretty decent. i get some nice low end extention, where the speaks drop off.

Worth nothing, the speakers are ACOUSTIC SUSPENSION (no ports)

My brother (not on a'gon) opined:

"Who knew the level of dorkdom in the world? U do need to turn the power up with lower frequency settings. Reason being, wider, slower waves need more watts to reach the same amplitude of percieved loudness. 80 hz is a little muddy to my ears for a sub. I'd try around 65 hz. Keep in mind that the frequencies are actually notes, so you may want to tweak it based on what key the music you are listening to is in. To figure out notes, keep in mind 110 is an "a" and use pythagorean fractions to tune down to the key you are in. 55 is also "a" ...."