Seeking Advice on Amp/Preamp or Integrated for Thiel PCS speakers


I know it all comes down to personal preference and I definitely need to try to hear the amps before I buy BUT I am looking for suggestions on amplification for a pair of Thiel PCS (87 dB, 4 ohms), which I recently purchased.  

I've been looking at the Rogue Audio Sphinx integrated, which has a lot of positive reviews. But I used to own a Threshold amp, which I really liked, and am thinking of getting another one and maybe pairing it with a tube preamp. Or maybe a NAD integrated...

a lot of options so just looking for advice to see if I'm on the right track or should be considering other options.


matthewva
I'm a little late to the party here, but I drive my Thiel PCSs with an older Krell integrated KAC400xi and love the combo.

I've also had Nuforce ref 9 v3 SE monoblocks driving them and it was great.  The monoblocks are getting upgraded so the Krell is back in play right now.  
David_ten, I was actually thinking of a Krell KSA-50S, if I go the separates route and can find one.
I use a Coda CSiB integrated to drive the pcs with excellent result.
Coda founded by Eric Lauchli, B.D. Dale and Lorin Peterson, former staff of Threshold.
Would have been a good amp, if in top electronic condition.

Cheers George 
This is really helpful, thank you.  Should have read that stereophile review closer to pick that up!

I used to own a S/150 but sold it long ago.
This is important for you to understand, as it tells you what the amp needs to be able to do to get the very best from those speakers.

Stereophile: measured tests.
Thiel PCS’s impedance magnitude (fig.1) hovers between 4 and 6 ohms over most of the band, and drops to 3 ohms in the lower midrange.
Note also the punishing combination of 4 ohms magnitude and 55 degrees capacitive phase angle at 120Hz.
This is a speaker that needs to be driven by an amplifier rated into 2 ohms to give of its best. But at least that amplifier doesn’t have to be very powerful; the PCS’s B-weighted sensitivity comes in above average at an estimated 89.5dB

BTW which Threshold do you own??

This means an amp that while not needing many watts (50w will do), but it needs to be able to pump good current into 2ohms and remain stable.
Look for amps that can almost double their 8ohm wattage into 4ohms and then again into 2ohms, this will ensure you have an amp that will deliver good amount of current.

The Rogue Audio Sphinx didn’t meet this into 2ohms, as Stereophile would have stated it in their measurements.
I would suggest maybe a John Curl Halo Integrated (it has a ESS Sabre32 Reference DAC inside it as a bonus) or a Pass Labs Integrated the Hegal 190 is also maybe a goer.

Cheers George