2. tech-talk
  3. 1230050616

Running dedicated AC mains .... need advice ....

I'm running two new 30ft dedicated lines of 12 ga Romex, and one 15ft line. The two longer lines will be one for digital sources and one for analogue sources, with the shorter line going to my subwoofer. I'm NOT going to standard AC wall recepticles, but am going to just bring the Romex straight in to the two PS Audio power conditioners using standard IEC connectors. I'm also taking the Romex straight to the sub itself ... bypassing the need for wall recepticles and AC power cables. The system is NOT moving from where it is at, so I see no need to add extra breaks in the lines at the walls.
Here then is my question : Should I use 3 copper ground rods driven in to the ground ? One for EACH Romex line ? This would keep the grounds separated and as short as possible.
Or should I use the Romex's own grounds back to the electrical panel, and ground at ONE place below the AC panel ? This would be MUCH longer ground runs, and seems that it would make for an inferior grounding scheme ?
Obviously, I need good advice.
Thanks
timtim

Showing 1 response by ozzy

ozzy's avatar
ozzy
7,581 posts
 
You are taking this way too seriously.

I have 3 dedicated lines all with 10 gauge going direct to the circuit panel. On the other end are Wattgate outlets.

Wiring direct will be a pain later down the road as your system changes , and it will look crappy and will not provide any sonic benifits.

Too many grounds and you will induce humm.

However, lifting the ground on your Digital might improve things.
More to discover