You are correct, other than the recommendation by Roger, we haven't really had any discussion on that. Vertical bi-amping is the way I roll these days and see no reason to go back, regardless of which pair of speakers I am using. I think using two Benchmark amps in that manner will yield very good results.
Running Benchmark AHB2 in bridged mode and 4 Ohm Speaker
Does running this amp in bridge mode mean each channel will see half the impedance i.e 2 Ohm each when connected to a 4 Ohm speaker. If so will this cause a problem when the speaker dips to 3 or 2 ohms?.
Anyone running Benchmark AHB2 in bridged mode with low impedance speakers?.
Anyone running Benchmark AHB2 in bridged mode with low impedance speakers?.