2. amps-preamps
  3. 170526-118749

Right Channel dropped out Bryston BP-26P (upgraded from BP-25P)

Long-time member/reader, first time poster  Moved my speakers to new location (used Cardas recommended measurements per post I read today on AudioGon site.  Long story short, turned on system, no right channel.  However, balance ctrl in center, I have left channel output in both speakers. Balance Ctrl fully to right channel...nothing.  Same whether it's switched to Mono or Stereo.  Found negative spade connector off on right speaker (did not seem to be touching positive terminal.  Reconnected still have the problem  Using Bryston 4Bcubed amp.  Both channel lights are green so I don't think it's the amp.Suspect preamp is taking a trip back to Bryston. However, also saw a post that said to clean input selector contacts, which I can do? Any suggestions welcome.  BTW  It's out of warranty
deanrk

Showing 1 response by oldhvymec

oldhvymec
5,101 posts
 
Check your connections and swap the cable at the power amp.
XLR first speaker cable next..

No idea if they have breakers or fuses. Seldom does the cheapest amp on the planet blow up from a cable tough.

 All that to say check ALL the fuses in the power amp!!!! Do they have fuses? They must.. Inside the power amp?

Bryston, I'm not familiar other than they have a great warrantee are as tough as nails, a great reputation and Canadian.

Regards
More to discover