Category: Preamps
BSG Qol Review February 2012.
I received my Qol unit late in the day last Saturday via Fed Ex. The Qol unit was very cold when I unpackaged it so I let it rest. Still, I was curious as heck so I did manage to play it for about 30 minutes that night.
I installed the Qol between My Pass XP-10 Preamp and Pass Labs X350.5 Amp. I was fortunate because I had another set of balanced interconnects just like my others and a Synergistic Tesla Power cord just like my others and I even had a 1A spare HIFI Tuning fuse available.
First impression, I thought it sounded kind of bright and with limited, if any, sound quality improvement.
The next day on Sunday, I played the Qol for a while, but again, I thought it was kind of bright sounding. I attributed it to needing some break in time. I then hooked the Qol up to a tuner and continuously played music 24/7 even when I was not actually listening to my music.
Well, I am a little embarrassed to post this but what the heck.
My earlier thoughts about the Qol sounding a little bright and the sound quality lacking turned out to be because I am using way too many speaker tweaks.
I found that the spades of my AudioPrism ground controls were touching the copper body of my Walker HDL Links, (On both L and R sides). In essence it was shorting out. It must have occurred when I was rerouting some of the cabling. Once I separated them the brightness went away, the sound quality greatly improved and the soundstage expanded every which way. I could actually hear that change occur when I was behind my speakers.
I wonder if I should just remove all of my speaker tweaks? Maybe later.
Since then, I have continued to break in the Qol by continually playing music through it. I believe the sound quality is still improving. So, anyone who says it is plug and play is not getting the full potential of the unit. Not sure how long the break in should take but 200 hours seems to work best for most electronic components.
Well my room also has problems that were preventing me from fully enjoying the Qol.
The Qol is certainly a different animal than what I have been used to. The Qol needs open area to do its magic.
So first off, I have had in my room for about a decade Argent Room Lenses.
For those unfamiliar to this room correction item, they are made with 3 pipes attached to a stand called dark matter. Anyway, the pipes are designed to work as a Helmholtz Resonator. There are 3 of these units in the room. Two were flanking the outer side of the speakers and one in the center of the room. These units worked fantastic, especially before my basement dedicated room was finished and I installed defined walls.
The Room Lens captured the side reflections and defined the soundstage.
Anyway, the Qol unit works almost the opposite by expanding the soundstage. So, I removed the Argent Room Lens from the room and played some music, and yes, the soundstage opened up.
The other problem I had was my Eggleston Andra 2 speakers were extremely toed in. The Toe in angle was so much that the image was directed to the center of my head. The music sounded like Olivia Newton John had her tongue in my ear. Not necessary a bad thing, but not correct for the recorded soundstage.
Well these speakers weigh 215 lbs and have 2” Audio Point spikes on them making it very difficult to just change the toe in angle.
I found that Herbie Labs sells a glider designed for Speaker spikes and with this glider I could move the speakers. So I ordered a set of them.
I received the Speaker spike Gliders a few days later and I went about reducing the amount of toe in. After the change, the soundstage became enormous.
I now have my speakers just about at a 90 degree angle and 36” from the side walls. But I will continue to experiment with placement further.
Well now it is almost 7 days later, how does the Qol sound? One of the big benefits of the Qol is the change in dynamics. I mean it is actually hard to find a volume set point to just leave alone. The music can go from soft to loud in a heartbeat. Funny, that even though the music appears to be quite louder, my Pass Labs Amp meter moves very little. This indicates to me that the increased dynamics is not pulling anymore current from my Amp.
With the Qol engaged, the music takes on a natural sound and image. The soundstage becomes very wide and deep. My speakers virtually disappear. I know that is said all the time, and before the Qol I thought my set up was awesome, but with the Qol you can hear deep into the recordings. The center image is the best I have ever heard. I can now hear background singers clearer and my toe tapping has increased.
The frequency extremes are heard with an authority. What I mean by that is that they are no longer buried in the mix but sound like they were part of the intended sound, if that makes sense.
Not all recordings were as hyped up as others. I guess each recording has its own reverb, echo, and different out of phase anomalies.
So the $4000 question, is it worth the money ?...
Well, if you want the deepest, widest soundstage and the wildest dynamics your components can handle, what price is that worth to you?
For me, it’s a keeper, no question.
Associated gear Click to view my Virtual System
