My Focus speakers arrived by freight with very loose screws/drivers. The bass was not right. I tightened the screws where I thought they were tight, but not overtightened. No problems with loose drivers or floppy bass since then (I did recheck them after last years home move). I never had a problem with loose screws on my Signature IIIs. I moved those locally. Speakers (as well as other equipment) get jostled quite a bit in freight transport.
Replacing driver screws with brass screws
There was some discussion about this on Millercarbon's thread about the Moab speakers, and I wanted to pursue the subject further without interfering with his thread.
As I stated there, I have heard about this practice for quite a few years, but never tried it because it seemed like one of those lunatic fringe ideas; and even though I actually really enjoy trying tweaks, and have found many of them effective, I just was not prepared for what this one did for the music coming out of my speakers.
Specifically, it improved the detail in ambient trails, focus in general, complex harmonics in voices and stringed instruments, and instrumental separation. It is not subtle, and it is immediately noticeable.
So, I am curious to know how many of you out there have tried this, and what your experience has been.
Thanks, John
As I stated there, I have heard about this practice for quite a few years, but never tried it because it seemed like one of those lunatic fringe ideas; and even though I actually really enjoy trying tweaks, and have found many of them effective, I just was not prepared for what this one did for the music coming out of my speakers.
Specifically, it improved the detail in ambient trails, focus in general, complex harmonics in voices and stringed instruments, and instrumental separation. It is not subtle, and it is immediately noticeable.
So, I am curious to know how many of you out there have tried this, and what your experience has been.
Thanks, John