Rel subwoofer voltage

Contact REL support, they’re very responsive and helpful.

Not sure where you are seeing where changing a fuse changes the input power voltage. The REL manual says voltage is set according to market with no mention of adjustment. 

This is an excerpt from one of their manuals.  Also, the rear of the sub shows the voltages listed with different fuse types:

REL Sub Bass Systems have a AC mains fuse located in the IEC receptacle where the power cord is plugged in. The fuses are located in a drawer that must be pulled out after the power cord is removed.

This drawer can be opened with a small flat blade screwdriver placed in the notch above the drawer.

There are two 5mm X 20mm 250VAC fuses in the drawer. The one farthest inside is the active fuse, and the one in the square holder is a spare. Fuse ampere ratings for input voltage of your region are printed on the outside of the amp panel next to the fuse drawer.

So, I am not saying Rel says that’s the way to change voltage...there may also be something internal besides the fuse that is different...I noted in my original post that on my Bel Canto I only had to change the fuse and wondered if maybe this is the same.

crn3371, I did write to them and they gave me the responsible answer of buying one in 220 and then when I go back to the US, sending it to California to get the amp swapped for a 110.  Seems like a LOT of hassle if I could do it myself.

Also, the rear of the sub shows the voltages listed with different fuse types

That's to save them screen printing two back plates. I looked at the busted REL Strada 3 plate amp I have and there is no dual windings etc. so it looks like they do not spec these and change out the traf on demand.

Thanks noromance...exactly the kind of information I was looking for.  
Guess I will have to wait then...doesn’t make any sense to get them 220 if I have to go through the expense and trouble of getting the amps replaced once stateside.