2. amps-preamps
  3. 185683-23267

Recommendation Request for Tube Power Amplifier

I have been using an all solid state system for many years. I hear so much about the "tube sound" experience. I'd like to check it out.The only experience with tube amps that I have comes from these two amps...

One is the Paragon System E Tube Preamp with phono. I bought this new about 1980. It uses six 12ax7 type tubes. I used it quite heavily for a few years. When it developed problems with the volume control, I replaced it with something I can't remember. In storage for a few decades, I pulled it out six months ago, cleaned all contacts, especially the volume pot. Still works!. I have measured this guy quite thoroughly. Phono gain is 43 dB. Distortion from Tape Out is below the noise floor at -95dB. Noise at 60 Hz and multiples is -60dB or better below 0dB recorded level.. Great numbers, even compared to modern preamps. I replaced the old 12AX7 tubes with six matched Genelex Gold Lion tubes.  I'm using this now as a phono preamp with the Koetsu RS and a step up transformer at 20x (Cinemag 1254). The table is a brand new Technics SL-1200G. I really like this sound.

But I'd like to try tube amplification again without spending a fortune.

What tube power amp would be a great match for this system? Years ago, I had a CJ MV75 power amp. I liked the sound, but hated the continual tweaking of the bias, even with brand new tubes. I sold it.

My budget is $3K or less.My system is not too efficient (86 dB sensitivity Revel 105 Bookshelf speakers and a self powered HSU sub, 100Hz xover), so I probably need more than the 3 watt/ch amps I see for some of the less expensive models. How much power do I need? I'm not sure. I've never heard any problems with the Levinson No. 27 or the present Bryston 2.5B cubed, but they both put out 100 W/ch or more. Balanced inputs would be great, but not absolutely necessary.

I consider my present system to sound quite neutral. I worked very hard to get it that way. I'm very pleased with the sound.

I want to exprience that warm tube sound if only to have a change of pace. Or maybe...

Thanks for your help!

128x128Ag insider logo xs@2xkevemaher

Showing 1 response by atmasphere

atmasphere's avatar
atmasphere
11,611 posts
 

@kevemaher 

If your speakers really are 86dB, something to consider is that tube power has always been expensive, which is why in the old days high efficiency speakers were common. It was not until the advent of cheap solid state power that a speaker as inefficient as yours could find a market!

So you'll need, in most rooms, at least 100 Watts (200 Watts would be better) and you can see how expensive that gets! So all SETs are not an option- and most vintage amps aren't either, unless your listening room is small or in a bedroom.

So if you are serious about this then getting a set of more efficient speakers would be a very good step.

Otherwise, there are some class D amps that sound very much like an excellent tube amp, on account of having similar distortion spectra to a tube amp. Its the distortion of any amp that is its sonic signature, FWIW.

More to discover