2. home-theater
  3. 1091375800

Question about my B&K reference 50 "Please help"

Well, I would sure appreciate any help I could get if someone could help me out. I purchased a new B&K reference 50 in May. I am running it with the B&K 200.5. My speakers are B&W nautilus HTM1, 803s(front), 805s (back). It has ran great since purchasing it in May, and has never been tampered with by anyone other than myself. Yet, Yesterday when the wife and I went into the media room.. Nothing would work... The reference 50 is hung on "PLEASE WAIT".. Its nonresponsive to the manual controls, as well as the remote control. I checked it again this morning, and it still says "please wait". I have read the owners manual cover to cover, and couldnt find anything within the manual itsself or the troubleshooting section, that referred to this problem.. any advice would be most appreciated. Thanks in advance.
yitbokb
5 responses Add your response
sogood51
2,157 posts
 
Have you tried unplugging it? It may reset itself when you plug it back in.

Dave
jamesw20
270 posts
 
Not to frighten you, but I hope you have a quality surge/line conditioner in the system. If not, then it's possible lightening or power surge could have damaged the unit.

Best of luck,

JWH
mt10425
1,138 posts
 
Turn it off at the main button. Unplug it. in fact, take the cord out of the IEC and leave it off for a bit. Plug the P/C back into the unit. Plug the cord back into the wall. Turn it back on at the power button. It's likely it'll reset. If not, off to B&K. I have a 307 receiver and I've had to do this a couple of times. Worked each time.
yitbokb OP
1 posts
 
Just wanted to let you guys know that I tried unpluging it from both ends (no bueno)and I let it sit for about twenty five minutes. It is protected by a very handsome and expensive peice of equipment, and the DVD, AMP, Projector, and Satelite reciever all seem to be running fine. So I guess im sending my new baby back home for a visit ASAP. Many thanks to MT10425, Jamesw20,and sogood51, for the helpful advice. It has all been most appreciated.
freakygreek
95 posts
 


Even though I don't have this unit I've read many posts concerning the Ref50. Do you have the latest firmware update.

You might find your answer here check:

www.hometheaterspot.com and follow the link to the B&K forum.

Best of luck
Log in to respond
More to discover
80x80
SVS SB1000PROGW
SVS 1000 Pro Subwoofer (Piano Gloss White) SVSSB1000PROGWOB
80x80
Monoprice - Monolith Htp-1
80x80
SVS SB1000PROBA
SVS SB-1000 Pro 12" Sealed Subwoofer SVSSB1000PROBAOB