2. amps-preamps
  3. 159067-110858

PS Audio BHK Pre Amp and Herron VTPH-2A Phono Pre Users

I just purchased a PS Audio BHK pre amp.  I am moving to the BHK because I need to start using XLR cables for long runs to my power amp.  

When using the BHK with the Herron VTPH-2A phono pre, the sound is flat - for want of a better word.  When I use my Herron VTSP-3A(r02) pre amp with the VTPH-2A, the sound is wonderful.  I'm new to tubes.  I think I have an impedance issue.  Anyone else using a Herron phono pre with a BHK pre amp having or had a similar experience.

128x128oldschool1948
tomic601's avatar
tomic601
12,911 posts
 
Wonderful 
oldschool1948's avatar
oldschool1948 OP
501 posts
 
Wonderful it is!
soliver
67 posts
 
I have 6m RCA’s running to my amps in the front, gear on the side.  No noise issue.  This is on multiple amp and preamp combos.
i have some very nice SE IC’s, but before I got these I had installed some way, way cheaper options and none exhibited noise issues.

i would stick with the Herron combo, and at least investigate getting some loaner long IC’s to make sure.
oldschool1948's avatar
oldschool1948 OP
501 posts
 
I’m convinced that long RCA interconnects could work. 
The SQ I get with XLR with the BHK/DSD is much better than RCA, so I intended to stick with it.
I have to downsize though.  I have a vintage McIntosh system that I haven’t used in over a year in my rev room. Once our remodeling projects are finished, the McIntosh gear goes up for sale. I will keep the Herron pieces for now anyway. 
More to discover