2. home-theater
  3. 1140988251

Proceed Avp2 problem- jumps to setup menu


I have the AVP processor with upgrade to AVP2 circuitry. Recently the unit has started going into main setup mode on its own. The front LED will indicate setup mode and I have to push the remote control (menu button) to exit the setup mode. It does this occasionally. Does this sound like some type of interference. I have tried blocking out the LED window on the front panel but it still jumps to setup mode. Could this be a problem with a circuit board component. Is there a fix available on-line or do you think the unit will require service ?

I contacted Madrigal but have not received a reply yet.

Appreciate any feedback.
Thanks , Dave
dpetrenko

Showing 1 response by ht4me

ht4me
17 posts
 
Dave,

Well sounds like one of two things, either you unit is
going into setup on it's own or somethng is telling it
to. If you have a Lexicon RT-10 the default IR codes
over lap the AVP2. This can be corrected by changing
your RT-10 to use the secondary code set. Next, is your
remote intermittenly sending the code to go into setup.
Could be a flaky remote or batteries need replacing. I
would first try covering the IR sensor on the front panel
(it's in the display window). See if it still happens,
if it doesn't your unit is picking up an IR signal
somewhere. If it still does the problem is internal. If
you are brave and take to proper static precautions you
could try reseating all the connections.

Hope this helps, good luck
More to discover