2. amps-preamps
  3. 150008-134308

Preamp for ATCSCM40A

Greetings,
I am about 2 months into a new pair of ATCSCM 40A active speakers. Loving them BTW, and I am wondering if I can do better in regards to the preamp. I love the punchy and fast sound the active speakers make with rock & pop music (80% of my collection) , however it is just a tad upfront and relentless in it’s presentation. Not unpleasant so, just a little bit on the cold / and very accurate side.

So I was after a sound just a little bit smoother - but not too much more smoother/darker than the naim 252. If it has more resolution and a bigger soudstage, then that would be a bonus as well.

The rest of my system is naim audio NDS/555DR streamer/DAC and 252 preamp with Supercap2DR. I am not that unhappy with my naim front end, just wondering if I can perhaps do better with my preamp.
To go to a naim 552 (the next model up) I can not afford to do that now (and possibly forever, as it is a rather expensive preamp). I want to keep my naim NDS/555DR as well, as I just love it.

Some shortlisted preamps I have looked at so far and within my budget were:

PS Audio BHK preamp - (very good, but an odd volume set up from all accounts, weird click noise when using it)

Pass Audio XP-22 - (very good, but the above PS Audio was similar in sound quality - but the Pass Audio has a much better volume control in a recent Stereophile Review)

Mola Mola Makua - (very good and not many negatives)

ATC - SCA2 - (an OK preamp by all accounts and it will clearly match their own active speakers. Just not sure it is smooth enough or very upfront like the SCM40A. Or for that matter good enough compared to others on this list).

I am pretty sure the ACT is a little bit restricted IRT the input signal via the XLR input. Only a input sensitivity of 1V ? So matching the preamp output signal can be tricky to find an ideal match with ? It prefers a lower signal impedence apparently, as the ARC Ref. 6 that I was looking at is a no-go because of a very high output impednace in the XLR of 600ohms. I was told to try for about a 50 ohms or under output from the preamp XLR output when matching with the ATC SCM40A.

Any other suggestions or advice ? Or am I going to be up for a sideways move at best with the preamp suggestions and budget from my above list ?


Any help very much appreciated.

Regards,
Peter
seadog1234

Showing 2 responses by seadog1234

seadog1234 OP
6 posts
 
Thank you Troy,

I have Naim Powerlines on all my naim stuff and on both my ATC speakers. Also have naim Superlumina DIN>DIN from NDS > 252 and all naim on naim Fraim as well as a Nordost QB powerboard.

Got a dedicated Ethernet switch with the exact Wireworld Starlight cables you suggested. 

I guess you can really get caught up with “must upgrade all the time” in this hobby. 

Do your rate the ATC electronics at all ? If I was to stray from a naim preamp, then the ATC SCA2 preamp was what I would be interested in. 

But as as you say, naim NDS and 252 are simply superb together.
seadog1234 OP
6 posts
 
Troy, all Powerlines connected to a Nordost Qbase 8 outlet powerboard then naim Powerline from that to a wall outlet, no power condition at all.

I’ll try some better power cords when I can. Thank you.
More to discover