Dave, I've asked this question in more than one thread because I wasn't sure if I was in the correct topic. Also, figured I would get more opinions this way. I'm not looking for the answer I want. If anything, I am more confused by varying opinions. I will weigh all of the recommendations and go with the most recommended approach. I do appreciate what everyone has to contribute.
power for mc452 and c2600
I'm relatively new to high end audio. Had a mcintosh integrated amp for few years and now decided to upgrade to separates. Just received c2600 preamp and awaiting on mc452 amp due to arrive sometime next week.
I don't know anything about power conditioners and protection devices. currently using monster surge protector. My questions:
1. what is the minimum protection device that one would use for my equipment
2. does it have to be a power conditioner or just surge protection
3. how much do these "power conditioners" contribute to the overall performance? Can you objectively measure their effect? Can they worsen the performance in any way by limiting power?
4. is there a real difference in relatively affordable (200-500) vs. higher price units (1000 and above) ?
5. What are you using and what is your experience with it?
6. Your recommendation on units with good reputation under $500
thank you
I don't know anything about power conditioners and protection devices. currently using monster surge protector. My questions:
1. what is the minimum protection device that one would use for my equipment
2. does it have to be a power conditioner or just surge protection
3. how much do these "power conditioners" contribute to the overall performance? Can you objectively measure their effect? Can they worsen the performance in any way by limiting power?
4. is there a real difference in relatively affordable (200-500) vs. higher price units (1000 and above) ?
5. What are you using and what is your experience with it?
6. Your recommendation on units with good reputation under $500
thank you
- ...
- 60 posts total
The ideal of 20amp or even 30amp from your circuit box and appropriate gauge electrical wiring would be ideal. I currently use a PS Audio P10 powerplant with PS Audio Power port outlets. (3 pairs) 6 outlets in total. I have 2 (250 Watt Amps) and all sources connected to P10, with exception of turntable and Tube Preamp. No hold back for power, it is there, no ’lag’. Having said that there is a third amplifier (350 Watt) Rotel RB 1590 plugged directly into one of the PS Audio wall outlets it is running B&W 804s. I use a basic Mx82 Furman line conditioner for my Tube preamp and turntable. Primary preamplifier C47 McIntosh connected to P10 for protection. |
ps7256 The ideal of 20amp or even 30amp from your circuit box and appropriate gauge electrical wiring would be idealA 30A line would be problematic because it would require a 30A receptacle. That won't be compatible with the plugs on your audio equipment, and I don't see any value in changing them to accommodate the 30A line. It would be better to use a 20A line and derate the cable to 10 AWG, which will help reduce voltage drop on the circuit. |
- 60 posts total