I tie captive cables in the "bow tie" and bind them with velcro straps. That is if you don't want to cut them. I usually don't cut them in case I sell or move it to another location. One other option I have done is weave the excess back and forth under the component, but that usually works its way out.
Power cable management
Is there any consensus on what to do with power cords that are too long? I figure the options are:
1). Coil neatly
2). Wrap neatly back and forth kind of like a bow tie
3). Leave as a rats nest and try to ignore it
I am currently employing option 3 but would like to staighten it up a little. This is for relatively flexible captive power cords on some older equipment I have. I also have some stuff that takes UECs but my aftermarket cords are made to just about the right length so there isn't really any excess to worry about.
1). Coil neatly
2). Wrap neatly back and forth kind of like a bow tie
3). Leave as a rats nest and try to ignore it
I am currently employing option 3 but would like to staighten it up a little. This is for relatively flexible captive power cords on some older equipment I have. I also have some stuff that takes UECs but my aftermarket cords are made to just about the right length so there isn't really any excess to worry about.