Pickup SRA - starting from a 500x microscope
"SRA and VTA are not identical or even interchangeable terms" They are infinitely connected, one follows the other, no they are not identical but they will follow each other, if you change one the other will change too. So it ultimately a matter of where/how one chose to measure, in my opinion that would be SRA which is the point closest to the source. I do however not subscribe to endless adjustments nor obsess over this, I usually just set it once and then forget about it till I change something on any particular setup. Good Listening Peter |
You can adjust the arm lift down with the microscopic allen wrench supplied in your tool kit for the SME. Midway in the rubber strip there a tiny hole that the allen wrench is inserted through to engage a adjustment screw below, this is a VERY finicky and fragile adjustment so be very careful. Your SME Manual have instructions on this on page 20 paragraph 536, if you don't have them manual one can be downloaded from Vinyl Engine Best of luck Peter |
Your Welcome, the allen wrench is a .09MM and a set containing it is available Here Remember even a VERY tiny adjustment at the base of the arm will result in a significant change in cueing height Best of Luck Peter |
